Item #: MR33: Right Outside Mirror
Installation Instructions

A hardcopy of the installation instructions is provided with each MR33 we send. We provide you with the following transcript for viewing on-line.


Brouwer Manufacturing Ltd. (Dual Brake .com) Item #: MR33
Driving Instructor’s Right Outside Mirror: Installation Instructions

Along with the wrench supplied with your mirror you will need a Robinson screw driver.

Remove the robinson screw from the back of the mirror: Please note that when the screw is removed the GLASS ASSEMBLY will be detached from the MIRROR HOUSING: Don’t allow the GLASS ASSEMBLY to fall out and break.

Check to make sure you have every thing that comes with the mirror:
  1. GLASS ASSEMBLY
  2. MIRROR HOUSING (with two C clamps and bolts attached to it)
  3. one wrench
  4. three rubber mounting strips

Screw the bolt back out of the C clamp as far as it will go without it being removed from the clamp. (When the bolt is screwed out of the clamp as far as possible it is impossible for the clamp to fall out of the MIRROR HOUSING.) Repeat this procedure for the second clamp.

Test fit the MIRROR HOUSING on your vehicles mirror. One of the three rubber mounting strips can be placed between the vehicles mirror housing and the MR33 MIRROR HOUSING: Determine which strip will make a better fit for your application.

With the rubber strip in place hold the MIRROR HOUSING at the desired location with one hand; with the other hand tighten the C clamp bolts. Once the MIRROR HOUSING has been hand tightened use the wrench to finish tighten.

With the MIRROR HOUSING attached to the vehicle reinsert the GLASS ASSEMBLY into the MIRROR HOUSING:

Note one: the tabs of the GLASS ASSEMBLY need to match up to the slots in the MIRROR HOUSING.

Note one: Avoid cross threading the robinson screw into the GLASS ASSEMBLY: If the screw is hard to turn in initially it may not be going back into its original female thread; back the screw out and reposition it so that the screw goes in more easily.


Valid XHTML 1.0 Transitional